protek r /炭2300mah堅持的RX包»紅色鋼筋混凝土-鋼筋混凝土車新聞

Saturday, September 22, 2007
ProTek R/C 2300mAh Stick RX Pack protek r /炭2300mah堅持的RX包

Categories - ProTek, Radio Equipment, Batteries, Electric, Products , trackback

protek r /炭2300mah堅持接收機包

A Main Hobbies today announced a new ProTek R/C brand Lithium Polymer receiver pack designed to fit vehicles that need a 2/3A style flat stick receiver pack.一個主要的業餘愛好，今天宣布了一項新的protek r /炭品牌的鋰聚合物接收包的設計，以適應車輛需要一個2/3a作風，堅持單位接收包。 This new receiver pack fits many vehicles where the current 2000mAh square style receiver pack will not fit, such as the XRAY XB8.這一新的接收包適合許多車輛目前的2000平方米的作風，接收包將不適合，如X射線xb8 。 This pack is currently one of the largest capacity Lithium Polymer receiver packs available in this size configuration.這個包是目前一個最大的容量鋰聚合物接收包可在這方面的大小配置。

Click more for further details…點擊更多進一步的細節…

This super light weight Li-Poly battery is designed to power the electronics of 1/10th & 1/8th scale gas powered race cars.這個超級重量輕，李聚電池設計，電力電子的1/10th ＆ 1/8th規模的天然氣動力的賽車。 Overall weight of your race car will be significantly reduced over the use of typical NiMh receiver packs.整體的重量您的賽車將會大大減少使用典型的鎳氫電池接收包。 The battery voltage to your receiver and servos will remain constant throughout the race with the use of a voltage regulator (required).電池電壓到您的接收器和伺服將保持不變，整個比賽過程與使用穩壓器（必填）。 A constant voltage for your servos will ensure consistent performance at the start and end of your race compared to typical NiMH receiver battery packs.一恆定電壓為您的伺服將確保一致的性能在開始和結束你的種族相比，典型的鎳氫電池接收機電池盒。

Runtime: 運行時間：
Don’t be thrown off by the capacity rating of Li-Poly battery packs, as you will get awesome runtime out this pack!不要被拋出關閉的能力評級李聚電池盒，你會得到可怕運行時指出，這包！ Unlike NiMH battery packs, Li-Poly battery packs do not lose voltage as quickly over time and can handle higher current draw than typical NiMH battery packs.不同的鎳氫電池盒，李聚電池盒不要失去電壓，很快的時間可處理高電流借鑒，比典型的鎳氫電池盒。 Given that Li-Poly battery packs provide a higher nominal voltage (7.4V nominal), the actual capacity of the battery pack when compared to a typical NiMH battery pack (6.0V nominal) is about 30% more than the rated value (so this pack would be about the same as a 3000mAh NiMH pack in total capacity).鑑於李聚電池盒提供一個更高的名義電壓（ 7.4 V名義），實際容量的電池匣時相比，一個典型的鎳氫電池匣（ 6.0v的名義）是約30 ％以上的額定價值（因此，這包會，大約同一作為一個3000mah鎳氫電池包在總容量）。 Also with the use of a voltage regulator, Li-Poly battery packs will produce the same voltage to your receiver and servos at the end of the pack as it does at the start.此外，與使用穩壓器，李聚電池盒將產生同樣的電壓到您的接收器和伺服在去年底的包，因為它確實在開始。 This means the useable capacity of the battery pack is significantly more than typical NiMH battery packs, because most NiMH battery packs will produce significantly less than the 6.0V nominal voltage once they get below half capacity (ie: your servos will be a lot more sluggish if your typical NiMH battery pack is below half capacity).這意味著可用容量的電池匣是明顯多於典型的鎳氫電池盒，因為大多數鎳氫電池盒將產生顯著低於6.0v電壓的名義，一旦他們得到一半以下的能力（即：您的伺服將有更多疲弱如果您的典型的鎳氫電池匣是一半以下的能力）。

Why must Li-Poly receiver packs be used with a voltage regulator? 為什麼要李聚接收包使用穩壓器？
Although the Li-Poly battery pack’s nominal voltage is 7.4V, when it is fully charged the voltage output is 8.4V.雖然李聚電池組的名義電壓是7.4 V ，當它完全落案控告該輸出電壓是8.4v 。 The 8.4V output exceeds the safety level of most receivers and servos on the market, so you must use a voltage regulator with these Li-Poly receiver packs to decrease the voltage to safe levels that your receiver and servos can accept.該8.4v輸出超過安全水平，最接收器和伺服對市場，所以您必須使用電壓調節器與這些李聚接收包，以減少電壓安全的水平，您的接收器和伺服可以接受。

IMPORTANT: 重要說明：
1. 1 。 You will need a Li-Poly specific charger to charge the pack (NiMH or NiCD only chargers WILL NOT WORK!)您將需要有一個李聚具體的充電器充電包（鎳氫或鎳鎘電池充電器，只有不會工作！）
2. 2 。 You must not over discharge the Li-Poly battery pack.您必須不超過履行李聚電池匣。
3. 3 。 Read the instructions carefully before operating this battery.閱讀說明之前仔細經營，這電池。

Specifications: 規格：
- Capacity: 2300 mAh -容量： 2 300M AH的
- Weight: 95 grams (including wire and connector) -重量： 9 5克（包括有線和連接器）
- Li-Po cell arrangement: 2S1P -利寶細胞的安排： 2 s1p
- Norminal voltage: 7.4 Volts -n orminal電壓： 7 .4伏特
- Discharge capability: 3C continuous (4.9A), 4C max (5.2A) -放電能力：連續3 C （ 4 .9a），第4 C最高（ 5 .2a）
- Dimension(mm): 85 x 30 x 16mm -外形尺寸（ m m）： 8 5× 3 0x十六毫米
- Connector: JR Style -連接器：兩人的風格
- Recommended Application: 1/10th & 1/8th scale vehicles that normally use a flat stick pack receiver battery -建議應用： 1 /10th＆ 1 /8th規模的汽車通常使用的一個單位，堅持包接收電池

Source: 資料來源： A-Main Hobbies一主要的業餘愛好 [amainhobbies.com] [ amainhobbies.com ]

Usage »使用»

If you republish any elements from this page on another website, including text, original pictures or formatted results please be sure to add a link back to this page as the source.如果您重新發布的任何內容，從本網頁上另一個網站，包括文字，圖片或原來的格式的結果，請務必添加一個鏈接回到此頁為源。