protek r /炭2300mah坚持的RX包»红色钢筋混凝土-钢筋混凝土车新闻

Saturday, September 22, 2007
ProTek R/C 2300mAh Stick RX Pack protek r /炭2300mah坚持的RX包

Categories - ProTek, Radio Equipment, Batteries, Electric, Products , trackback

protek r /炭2300mah坚持接收机包

A Main Hobbies today announced a new ProTek R/C brand Lithium Polymer receiver pack designed to fit vehicles that need a 2/3A style flat stick receiver pack.一个主要的业余爱好，今天宣布了一项新的protek r /炭品牌的锂聚合物接收包的设计，以适应车辆需要一个2/3a作风，坚持单位接收包。 This new receiver pack fits many vehicles where the current 2000mAh square style receiver pack will not fit, such as the XRAY XB8.这一新的接收包适合许多车辆目前的2000平方米的作风，接收包将不适合，如X射线xb8 。 This pack is currently one of the largest capacity Lithium Polymer receiver packs available in this size configuration.这个包是目前一个最大的容量锂聚合物接收包可在这方面的大小配置。

Click more for further details…点击更多进一步的细节…

This super light weight Li-Poly battery is designed to power the electronics of 1/10th & 1/8th scale gas powered race cars.这个超级重量轻，李聚电池设计，电力电子的1/10th ＆ 1/8th规模的天然气动力的赛车。 Overall weight of your race car will be significantly reduced over the use of typical NiMh receiver packs.整体的重量您的赛车将会大大减少使用典型的镍氢电池接收包。 The battery voltage to your receiver and servos will remain constant throughout the race with the use of a voltage regulator (required).电池电压到您的接收器和伺服将保持不变，整个比赛过程与使用稳压器（必填）。 A constant voltage for your servos will ensure consistent performance at the start and end of your race compared to typical NiMH receiver battery packs.一恒定电压为您的伺服将确保一致的性能在开始和结束你的种族相比，典型的镍氢电池接收机电池盒。

Runtime: 运行时间：
Don’t be thrown off by the capacity rating of Li-Poly battery packs, as you will get awesome runtime out this pack!不要被抛出关闭的能力评级李聚电池盒，你会得到可怕运行时指出，这包！ Unlike NiMH battery packs, Li-Poly battery packs do not lose voltage as quickly over time and can handle higher current draw than typical NiMH battery packs.不同的镍氢电池盒，李聚电池盒不要失去电压，很快的时间可处理高电流借鉴，比典型的镍氢电池盒。 Given that Li-Poly battery packs provide a higher nominal voltage (7.4V nominal), the actual capacity of the battery pack when compared to a typical NiMH battery pack (6.0V nominal) is about 30% more than the rated value (so this pack would be about the same as a 3000mAh NiMH pack in total capacity).鉴于李聚电池盒提供一个更高的名义电压（ 7.4 V名义），实际容量的电池匣时相比，一个典型的镍氢电池匣（ 6.0v的名义）是约30 ％以上的额定价值（因此，这包会，大约同一作为一个3000mah镍氢电池包在总容量）。 Also with the use of a voltage regulator, Li-Poly battery packs will produce the same voltage to your receiver and servos at the end of the pack as it does at the start.此外，与使用稳压器，李聚电池盒将产生同样的电压到您的接收器和伺服在去年底的包，因为它确实在开始。 This means the useable capacity of the battery pack is significantly more than typical NiMH battery packs, because most NiMH battery packs will produce significantly less than the 6.0V nominal voltage once they get below half capacity (ie: your servos will be a lot more sluggish if your typical NiMH battery pack is below half capacity).这意味着可用容量的电池匣是明显多于典型的镍氢电池盒，因为大多数镍氢电池盒将产生显着低于6.0v电压的名义，一旦他们得到一半以下的能力（即：您的伺服将有更多疲弱如果您的典型的镍氢电池匣是一半以下的能力）。

Why must Li-Poly receiver packs be used with a voltage regulator? 为什么要李聚接收包使用稳压器？
Although the Li-Poly battery pack’s nominal voltage is 7.4V, when it is fully charged the voltage output is 8.4V.虽然李聚电池组的名义电压是7.4 V ，当它完全落案控告该输出电压是8.4v 。 The 8.4V output exceeds the safety level of most receivers and servos on the market, so you must use a voltage regulator with these Li-Poly receiver packs to decrease the voltage to safe levels that your receiver and servos can accept.该8.4v输出超过安全水平，最接收器和伺服对市场，所以您必须使用电压调节器与这些李聚接收包，以减少电压安全的水平，您的接收器和伺服可以接受。

IMPORTANT: 重要说明：
1. 1 。 You will need a Li-Poly specific charger to charge the pack (NiMH or NiCD only chargers WILL NOT WORK!)您将需要有一个李聚具体的充电器充电包（镍氢或镍镉电池充电器，只有不会工作！）
2. 2 。 You must not over discharge the Li-Poly battery pack.您必须不超过履行李聚电池匣。
3. 3 。 Read the instructions carefully before operating this battery.阅读说明之前仔细经营，这电池。

Specifications: 规格：
- Capacity: 2300 mAh -容量： 2 300M AH的
- Weight: 95 grams (including wire and connector) -重量： 9 5克（包括有线和连接器）
- Li-Po cell arrangement: 2S1P -利宝细胞的安排： 2 s1p
- Norminal voltage: 7.4 Volts -n orminal电压： 7 .4伏特
- Discharge capability: 3C continuous (4.9A), 4C max (5.2A) -放电能力：连续3 C （ 4 .9a），第4 C最高（ 5 .2a）
- Dimension(mm): 85 x 30 x 16mm -外形尺寸（ m m）： 8 5× 3 0x十六毫米
- Connector: JR Style -连接器：两人的风格
- Recommended Application: 1/10th & 1/8th scale vehicles that normally use a flat stick pack receiver battery -建议应用： 1 /10th＆ 1 /8th规模的汽车通常使用的一个单位，坚持包接收电池

Source: 资料来源： A-Main Hobbies一主要的业余爱好 [amainhobbies.com] [ amainhobbies.com ]

Usage »使用»

If you republish any elements from this page on another website, including text, original pictures or formatted results please be sure to add a link back to this page as the source.如果您重新发布的任何内容，从本网页上另一个网站，包括文字，图片或原来的格式的结果，请务必添加一个链接回到此页为源。