Avid 13mm Precision Carpet ‘Batch 2’ Springs

New from Avid Racing Concepts comes their 13mm Precision ‘Batch 2’ Springs. These new additions will be used on high grip office carpet, or heavier vehicles like stadium trucks. The Avid Springs are specifically designed for carpet racing by having stiffer rates and shorter lengths – this allowing you to get to your low ride heights easily. The springs are left raw so the spring rate and action of the spring is not compromised from any extra chemical processes, just like Avid’s famous springs that they released in 2013!

Spring Features
– Engineered for carpet racing, Avid springs feature higher spring rates and shortened lengths: 40mm front, 56mm rear, allowing ultra-low ride heights.
– Front springs are intentionally short and can’t be accurately tested at 1″ compression due to coil bind.
Modern cars run under 23mm stroke in the front, which aligns with our design to push the spring right to very edge but not go over it.
– Each batch is measured for the average spring rate (lb/in) after passing in-house testing using a precision $3k Chatillon digital spring rate tester.
– Made from raw, uncoated ASTM-spec spring wire for consistency and factory-like polish potential.
– Laser etched with black markings for Batch 2 on the side above where the wire ends: large dash = 5 dots, small dash = 1 dot.

Source: Avid [avidrc.com]