JConcepts RC10 1989 Stealth 3D Printed Option Parts

JConcepts has release a number of 3D printed option for the Team RC10 1989 Stealth.  The range for the for the re-released 1:10 2WD Buggy includes a front bumper.  With no front bumper in the kit, JConcepts designers created and printed a new direct bolt-on item to give this piece of RC history the proper front protection it requires.  Also SLS printed  PA-12 material, they are offering a new battery mount location and add an electronics plate.  The battery compartment is designed to fit a shorty 2s lipo battery placing it in a forward position.  The rear of the 3D printed item is reserved for speed control mounting area with tunnel access to keep wiring clean and simple to receiver.  Noticing room for a clean install of body mount pads on the side of the chassis, JConcepts has created and printed a new direct bolt-on item to give the proper location for hook and loop tape fastening.  Designed to fit the chassis; while utilising existing holes the body mount pads require 4-40 hardware (not included).  With the parts tested during the Team Associated Vintage Championships in Las Vegas, Nevada, Ryan Maifield put it through the paces and the item passed with flying colours.

Source: JConcepts [jconcepts.net]