T-Works aluminium conical washers
From T-Works come these black anodised conical washers. Made from high quality aluminium, the washer features a 3mm bore and they come in a pack of 10 pieces.
Source: T-Works [rc-tworks.com]
- Red RC Network:
- Red RC |
- Red RC Events
T-Works MBX8-R arm stiffeners & engine screw set
T-Works have introduced new carbon fibre suspension arm stiffeners for the Mugen MBX8-R buggy. Available for the lower rear arms, they help reduce overall arm flex while preventing the built up of dirt. The stiffeners are available in 1mm and 1.2mm variants with the different thickness helping to further fine-tune the flex characteristics. Included with the sets comes suitable hardware. Also for the MBX8-R is an engine mount washer and screw set.
View the engine mount washer & screw set here
T-Works MBX8R rear wing mount plate
T-Works have produced this graphite rear wing mount plate for the Mugen MBX8R. The plate is very lightweight yet helps to increase the lateral stiffness and integrity of the rear wing mount.
T-Works MBX8R flywheel tool
T-Works have produced this new flywheel tool for the MBX8R. One end of the tool features a general flywheel wrench, while the other end is specific to the Mugen, shaped to firmly lock onto their clutch assembly. The entire tool has been made from 7075 aluminium and has been black hard anodised for increased durability.
T-Works 22 & 16g tungsten balance weights
Coming from T-Works are two more tungsten weights, this time in 22 and 16 grams. The use of the heavy material allows for a low profile design of 1.4mm while still adding a good amount of weight compared to brass weights, with the adhesive backside ensuring easy mounting. The weight comes laser-engraved for easy identification.
Source: T-Works [rc-tworks.com]
T-Works MBX-8R high density foam filters
T-Works have released this set of 10 high density foam filters for the Mugen MBX-8R. A direct fit for the MBX-8R, the high density foam allows for maximum airflow for the best performance without compromising protection. Sold in bulk as a more cost effective option.
Source: T-Works [rc-tworks.com]
T-Works 10 & 5g tungsten balance weights
Coming from T-Works are two new tungsten weights, in 10 and 5 grams. The use of the heavy material allows for a low profile design while still adding a good amount of weight compared to brass weights with the adhesive backside ensuring easy mounting of the weight. The weight comes laser-engraved for easy identification.
Source: T-Works [rc-tworks.com]
T-Works MTC2 graphite lower arms
New for the MTC2 from T-Works are a new set of front and rear graphite lower arms. The new arms sport an additional rib that makes the part stronger but also makes it stiffer. Sold as pairs, they are a direct replacement part.
