November 16, 2019

WellRC WellCut body post & exhaust stinger marker

WellRC have introduced two new WellCut products that help to make preparing on-road body shells a lot easier. First up is the WellCut for 1/8th scale body shells, a system that helps to locate the body posts when prepping already painted body shells. Place the WellCuts over the front body posts with the magnets facing the rear of the car and secure them with two body clips. After using the WellCut template to cut out the rear of the car, set the body on the car and drop the front two outer magnets into place. The super strong magnets will immediately centre themselves. Use a fine tip black permanent marker to mark the centres of the magnets. Remove the body and cut the two holes with a body reamer and you’re set. Available in two sizes to fit 7 and 8mm diameter front posts.

Also new is the WellCut for exhaust outlets. Just slide the WellCut into place and align it so the outer edge sits parallel against the body. Drop the included outer magnet into place and use a fine tip permanent marker to mark the centre hole. Use a body reamer to cut the hole and enjoy perfect results time after time. The universal size fits most 1/10 and 1/8 exhaust stingers.

Source: 1up Racing [1upracing.com]



Usage

If you republish any elements from this page on another website, including text, original pictures or results please be sure to add a link back to this page as the source: