MonacoRC has developed a line of reinforcements, in three different models, called Body Tuck. Body Tuck is a reinforcement for bodyshells specially designed to have the following characteristics of Lightness, Resilience & Simplicity. The reinforcements are made with supports specially designed for the most popular car bodies on the market and are made with resin 3D printing. Resin 3D (SLA) printing allows the piece to have a considerably higher toughness and resilience than the classic filament printing, the final aesthetic finish of the product is also indisputable, for which MonacoRC have paid great attention both in the production and in the design of the product.
Wing Tuck is a small support that allows you to maximise the rear aerodynamic load of your body by reducing the deflection of the flow rate from the wing load. Side Tuck supports allow you to avoid bending of the sides of the bodyshell, this keeps your body aligned, and allows you to take full advantage of the aerodynamic load given by its specific shapes. The Rear Tuck supports allow you to stiffen the rear part of your bodyshell, which leads to two benefits of preventing the rear flaps of the wheel arch from opening during full load while also Protecting the bodyshell from tucking into the rear wheel following contact with another car, and thus, prevents DNF or loss of important time from your run.