The MSE Performance Parts straight plate is made to assemble all bulkheads aline to the chassis centre line. It connects not only left and right but also front and rear. It is easy to use even in between runs. It helps for a proper assembly and prevents any unusual behave of the car. It is recommended to use in combination with the tweak stick. The MSE Performance Parts Carbon Tweak Stick is made to pin the car down onto a flat surface with one hand, while tightening the upper deck screws with the other hand. This process will take out chassis tweak and prevents any unusual behave of the car. It is recommended to use in combination with the straight plate.
New for the MTC2 from MSE Performance Parts come a number of carbon option parts for the car. Firstly there is new upper arm brackets for the front and rear of the car. Made from 2.5mm thick carbon, these lightweight parts offer 4° and 5° caster at the front or 0° and 2° caster at the rear. There are also a pair of upright levers also made from the same carbon material.
MSE Performance Parts Germany have released some new carbon options for the Mugen MBX8 buggy. First up this extended battery box for easy installation of your batteries without the cable chaos. Recommended for use with the Mugen Seiki rubber grommet for better cable routing and sealing, the top carbon plate gives it that factory look and comes with an engraved MSE logo. Also for the MBX8 are a pair of 2mm thick carbon lower arm plates for both the front and the rear. These torsion-resistant carbon plates work best in very hot weather conditions and high grip surfaces or carpet tracks.