September 16, 2011

Robitronic Mantis updated version

Robitronic-Mantis-UpdatedVersion

Robitronic release an updated version of their Mantis 1/8 scale nitro 4WD stadium truck. The new version comes with a 2.4GHz 16-model memory transmitter, genuine Savöx SC-0252 Servo steering and throttle servos, receiver battery pack and charger, a new 4.6cc 8-port big block engine, L/R thread turnbuckles all round, full ball bearings and front and rear anti-roll bars as well as big bore shock absorbers with 3.5mm piston rods.

Click here to view more pictures


September 16, 2011

Mazzara dominates 11th Annual Race against Cancer

Mazzara dominates 11th Annual Race against Cancer

This past weekend TLR driver Anthony Mazzara attended the 11th Annual Race against Cancer at McCulloughs Raceway in Sarver, PA. There were over 150 entries that included racers across six different states. Anthony TQ’d and Won the 1/8 Electric Buggy class with his TLR 8ight-E 2.0 while qualifying second in both 1/8th Nitro buggy and truggy. After the 30 minute A-mains in the nitro classes Anthony was able to pull off the win in both 1/8th Nitro buggy and truggy with his TLR 8ight 2.0 and 8ight-T 2.0 respectively. This gave Anthony the podium sweep in all three 1/8th classes. This was the 11th year of the event and their goal was to raise at least $10,000 dollars donating all proceeds to the American Cancer Society. Something that makes this more special is each year Anthony Mazzara raffles off his TLR 8ight 2.0 that was raced during the event and donates the proceeds to the event.  Anthony raffled off his TLR 8ight 2.0 to the winner of the raffle Mike Lloyd (seen in the photo holding his new TLR 8ight 2.0) adding an additional $400 to the $11,000 dollars for the weekends race.

Source: TLR [tlracing.com]


September 16, 2011

Casey Peck does the double at Tumbleweed Classic

Casey Peck does the double at Tumbleweed Classic

TLR was out in full force for the 18th annual Tumbleweed Classic hosted by the ARCOR R/C Club in Albuquerque, New Mexico. In recent years the club has raised enough money to add a separate Nitro only track. This keeps the heavy 1/8th cars off of the super high bite surface of the electric track. A mixture of loamy dirt and 600 pounds of sugar is known for its smooth high traction and 2 ROAR Electric National events. The two separate tracks make for an event that offers a challenge to any driver on the two opposite ends of the race surface spectrum.

Continue reading the report here


September 16, 2011

Losi 1/14th scale Mini 8ight buggy

Losi 1/14th scale Mini 8ight buggy

Based upon the ROAR-Championship-winning 8ight buggy, this brushless-powered prodigy is the ultimate mini buggy. Its 1/14-scale size allows it to handle tougher terrain while mastering the outrageous power and speed from the brushless system. Better still, the Mini 8ight comes with everything you need to get started, including transmitter, rechargeable NiMH battery pack and charger. The Mini 8ight comes ready to run with a Losi radio system that has Spektrum 2.4GHz technology. You won’t ever need to worry about frequency conflicts or interference. Plus, it features a shorter antenna, requires fewer batteries and allows you to run more than six vehicles at a time.

View more information and images here


September 14, 2011

Bruno Heremans wins Rd6 of Benelux Championship

Bruno Heremans wins Rd6 of Benelux Championship

The penultimate round of the BeNeLux Championships was run last weekend at Liege, Belgium. X Factory’s Bruno ‘Elvo’ Heremans and Stefan Mesker dominated the event with their X-6 Squareds. Mesker TQ’d the Liege event with Heremans took second on the grid and the pair dominated the three A mains with Elvo taking the first two and Stefan the third to finish 1st and 2nd respectively with Wesley Van Helmond in 3rd. After six of seven rounds, with five to count,  Stefan Mesker leads the Championship one point ahead of Heremans.  Elvo was forced to miss the first race due to a skiing injury, so the pressure is on him to do well in the final race.  Nobody else is within 5 points of Mesker, so Stefan can only lose the Championship if Elvo TQs and wins and Stefan finishes 4th or below.

Source: X-Factory [xfactoryrc.com]


September 13, 2011

2011 JConcepts Southern Nationals – Announcement

2011 JConcepts Southern Nationals - Announcement

The organisers of this year’s JConcepts Southern Nationals & R/C Expo in West Monroe, LA that takes place on October 21-23 got in touch to tell use about their event. Last year they had 260 entries and this year they will have over 325 paid entries, more have entered but entry is capped. The event will take place in a 5000 seat arena with a 300’x190′ dirt floor that they will build a 100’x200′ track in the center with a 15′ tall drivers stand. Adam Drake said last year that stand was the 2nd largest that he’s ever seen after the one at the World’s in Las Vegas. The facilty is air conditioned along with an exhaust system so that the race environment is second to none. Ryan Lutz, Barry Pettit, Jason Rouna & Jason Branham are some of the marquee names that are confirmed to race at this years event and they are waiting on more confirmations for more nationally recognized drivers. You can view more information and place your entry for the event here.


September 13, 2011

Jared Tebo double at ROAR 1/8 EP Offroad Nats

Jared Tebo double at ROAR 1/8 EP Offroad Nats

The 2011 ROAR 1/8 Electric Off-Road Nationals were held September 9-11 at The Hobby Plex in Omaha, Nebraska. Team Orion would show up to this years Nationals with their Super Star 1/8 Team. Ryan Cavalieri just coming off his double World Championship Wins in Finland just 1 month ago. Jared Tebo just taking 2 National Championships at the 1/10 ROAR Nationals a few weeks ago. Mike Truhe, defending ROAR 1/8E National Champion. And Cody King, current 1/8 Nitro World Champion.

Continue reading the report here


September 13, 2011

Serpent Cobra 811 anti-roll bar shaft

Serpent Cobra 811 anti-roll bar shaft

New for the Serpent Cobra 811 Buggy & Truggy is this anti-roll bar shaft. Precision machined from spring steel, it fits in the ball-raced anti-roll bar holders of the Cobra buggy (front and rear) and Truggy (rear). The straight anti-roll bar wires, which are sold separately, are fitted in the slots in the shaft of the aluminium holders and then fastened with set screws. This system allows the mounting of other thicknesses of anti-roll bar wires in very little time. The straight wires are available 1.8mm, 2.0mm, 2.1mm, 2.3mm, 2.5mm and 2.7mm versions.

View more images here


Tonisport
Mibosport
LC Racing
VP Racing
T-Works